Safety operating procedures for drilling and milling machines
2022-09-22


1. Before operation, check whether the handle of each part of the milling machine is normal, fill the lubricating oil according to the regulations, and test run at low speed for 1~2 minutes before operation;


2. Work clothes should be worn before work, female workers should wear work hats, and gloves are strictly prohibited during operation;


3. The clamping workpiece should be stable, and loading and unloading, tool setting, measurement, speed change, tightening the mandrel and cleaning the machine tool must be carried out after the machine tool is stopped;


4. It is forbidden to place measuring tools, workpieces and other sundries on the workbench;
5. When driving, check whether the workpiece and the milling cutter are in the right position of each other;


6. When the milling machine automatically passes the tool, the handle and the wire buckle should be disengaged; The workbench cannot go to the two limit positions, and the limit block should be firmly placed.


7. When the milling machine is running, it is forbidden to clean the machine tool with bare hands or cotton yarn, and people cannot stand in the tangent direction of the milling cutter, let alone blow chips with their mouths;


8. Before moving the workbench and the lifting table, the fixing screws must be loosened; When not moving, tighten the fixing screws;


9. The tool holder, tie rod, chuck and knife should be installed and tightened before start-up, and the spindle shall not be used to rotate to help loading and unloading;


10. After the work is over, the power should be turned off, the machine tool should be cleaned, and the handle should be placed in an empty position, and the workbench should be moved to the center.


Company website:http://www.huisnmach.com

<< Low noise multi-function household drilling and milling machine

>> CNC machine tool family's big brother -------CNC milling machine